中文名称: BV6 促销  一键复制产品信息
英文名称: BV6
CAS No: 1001600-56-1
分子式: C70H96N10O8
分子量: 1205.67
B10042 BV6 ≥98%(HPLC) (普西唐-psaitong)
包装规格:
5mg 25mg 100mg in glass bottle
产品简介:
一种凋亡抑制蛋白(IAP),它通过激活NF-κB促进胶质母细胞瘤癌干样细胞分化。
溶解性:
溶于DMSO(≥58mg/mL)
储备液保存:
-80°C, 2 years
-20°C, 1 year
体内实验:
1、请依序添加每种溶剂: 10% DMSO→40% PEG300→5% Tween-80→45% Saline
Solubility: ≥ 2.5 mg/mL (2.07 mM); 澄清溶液
此方案可获得 ≥ 2.5 mg/mL(饱和度未知)的澄清溶液。
以 1 mL 工作液为例,取 100 μL 25.0 mg/mL 的澄清 DMSO 储备液加到 400 μL PEG300 中,混合均匀;再向上述体系中加入 50 μL Tween-80,混合均匀;然后再继续加入 450 μL 生理盐水 定容至 1 mL。
2、请依序添加每种溶剂: 10% DMSO→90% (20% SBE-β-CD in Saline)
Solubility: ≥ 2.5 mg/mL (2.07 mM); 澄清溶液
此方案可获得 ≥ 2.5 mg/mL(饱和度未知)的澄清溶液。
以 1 mL 工作液为例,取 100 μL 25.0 mg/mL 的澄清 DMSO 储备液加到 900 μL 20% 的 SBE-β-CD 生理盐水水溶液 中,混合均匀。
3、请依序添加每种溶剂: 10% DMSO→90% Corn Oil
Solubility: ≥ 2.5 mg/mL (2.07 mM); 澄清溶液
此方案可获得 ≥ 2.5 mg/mL(饱和度未知)的澄清溶液,此方案实验周期在半个月以上的动物实验酌情使用。
以 1 mL 工作液为例,取 100 μL 25.0 mg/mL 的澄清 DMSO 储备液加到 900 μL玉米油中,混合均匀。

<1mg/ml表示微溶或不溶。
普西唐提供的所有化合物浓度为内部测试所得,实际溶液度可能与公布值有所偏差,属于正常的批间细微差异现象。
请根据产品在不同溶剂中的溶解度选择合适的溶剂配制储备液;一旦配成溶液,请分装保存,避免反复冻融造成的产品失效。
靶点:
IAP
体外研究:
HCC193 has an IC50 of 7.2 μM in MTS assays, while H460 cells are not reduced to 50% viability even with 30 μM BV6 treatment. Administration of 1 μM BV6 to HCC193 cells induces complete depletion of cIAP1 levels at 1 hour post-treatment, while a decrease in XIAP levels is not seen until 24 hours following addition of drug. Similarly, 5 μM BV6 fully depletes cIAP1 at 1 hour and begin to reduce XIAP at 24 hours in H460 cells. In parallel findings, cIAP1 levels are decreased in response to a small dose of 0.25 μM BV6 in both cell lines, whereas trace amounts of XIAP are still present at 5μM BV6. HCC193 cells demonstrates noticeable cleaved caspase-3 levels beginning 12 hours post-incubation with 1μM BV6, and cleaved caspase-3 levels continued to increase in a time-dependent manner over 48 hours. Treatment of HCC193 cells with 1 μM BV6 for 24 hours causes a significant survival curve shift in HCC193 cells relative to DMSO-treated cells, with a DER=1.38 (p<0.05). BV6 (2 and 5μM) significantly represses BrdU incorporation in ectopic and eutopic (disease-free and myomas) ESCs. An ~30% decrease of BrdU incorporation is observed in both groups after treatment with 5 μM BV6.
体内研究:
Murine cIAP-1, cIAP-2 and XIAP expressions are clearly observed in the cytoplasm of both epithelial and stromal cells of implants, whereas Survivin is mainly expressed in the nuclei BV6 treatment for 4 weeks attenuated the intensity of IAPs expression. The size of lesions range from ~2 to 7 mm in diameter. The monolayer epithelial cell lining of the cyst isshown. After immunohistochemical staining, cytokeratin and vimentin are positively stained, whereas calretinin is negative. After BV6 treatment for 4 weeks, the total number of lesions(4.6 versus 2.8/mouse), the average weight (78.1 versus 32.0 mg/mouse) and the surface area (44.5 versus 24.6 mm2/mouse) of lesions are significantly less than in the controls. In the endometrial gland epithelia or stroma, the percentage of Ki67-positive cells decreases afterBV6 treatment.
细胞实验:
细胞系:HCC193 和 H460 细胞
浓度:~30 μM
处理时间:~48 小时
方法:细胞活性使用CellTiter 96®含水非放射性细胞增殖试剂盒进行测定。5000细胞/孔以一式三份接种于96孔板。细胞附着在孔壁之后,将逐渐增加浓度的BV6加入不同的孔中。对照组暴露于相同浓度的DMSO。24小时后,3μg/mL的MTS和25 μM PMS加入到每孔中。37 °C下在潮湿的5% CO2中培养2小时后,板在490-nm吸光度下于酶标仪上读取数据。单个样品的相对细胞活性通过将它们的吸光度与相应的对照组归一化进行计算。IC50值使用Prism 5.01计算。对于TNFα中和抗体试验,10 μg/mL infliximab存在或不存在下,细胞暴露于1和5 μM BV6,测定在24小时后进行。板在490-nm吸光度下于酶标仪上读取数据。
保存条件:
-20℃
注意事项:
1、为了您的安全和健康,请穿实验服并戴一次性手套操作。
2、以上信息仅做参考交流之用。
UN码:
HazardClass:
危害声明:
安全说明:
搜索质检报告(COA)

分析证书(COA)

Lot/Batch Number

本计算器可帮助您计算出特定溶液中溶质的质量、溶液浓度和体积之间的关系,公式为:
质量 (g) = 浓度 (mol/L) x 体积 (L) x 分子量 (g/mol)

摩尔浓度计算公式

  • =
    *
    *
    *选择对应的单位 *空出希望得到的变量,填写另外两个变量

用本工具协助配置特定浓度的溶液,使用的计算公式为:
开始浓度 x 开始体积 = 最终浓度 x 最终体积

稀释公式

稀释公式一般简略地表示为:C1V1 = C2V2 ( 输入 输出 )

  • * = *

连续稀释计算器方程

  • 连续稀释

  • 初始浓度:
  • 稀释倍数:
  • 计算结果

  • C1=C0/X C1: LOG(C1):
    C2=C1/X C2: LOG(C2):
    C3=C2/X C3: LOG(C3):
    C4=C3/X C4: LOG(C4):
    C5=C4/X C5: LOG(C5):
    C6=C5/X C6: LOG(C6):
    C7=C6/X C7: LOG(C7):
    C8=C7/X C8: LOG(C8):
请在下列方框中输入相关信息后点击计算,可以得到母液配置方法和体内配方的制备方法:
举例:给药剂量是10 mg/kg,每只动物体重20g,给药体积100 μL, TargetMol | Animal experiments  一共给药动物10只,您使用的配方为5%TargetMol | reagent DMSO 30%PEG300 5%Tween 80 60%Saline/PBS/ddH2O, 那么您的工作液浓度为2mg/mL
母液配置方法: 2 mg 药物溶于 50 μLDMSOTargetMol | reagent  ( 母液浓度为 40 mg/mL ), 如您需要配置的浓度超过该产品的溶解度,请先与我们客服联系。
体内配方的制备方法: 取 50μLDMSOTargetMol | reagent  母液,添加 300 μLPEG300TargetMol | reagent  混匀澄清,再加 50μLTween80, 混匀澄清,再加 600μLSaline/PBS/ddH2OTargetMol | reagent ​ 混匀澄清

方案所需的各种助溶剂如: DMSO , PEG300 / PEG400 , Tween 80 , SBE-β-CD , 玉米油 等, 均可点击跳转或在网站搜索购买。
 
以上为“动物实验计算换算器”的使用方法举例,并不是具体某个试剂的配制,请根据您的实验动物和给药方式选择适当的溶解方案。
第一步:请输入基本实验信息(考虑到实验过程中的损耗,建议多配一只动物的药量)
第二步:请输入动物体内配方组成(配方适用于不溶于水的药物;不同批次药物配方比例不同,请联系普西唐客服为您提供正确的澄清溶液配方)
+
+
+

计算结果:

工作液浓度 mg/ml;

DMSO母液配制方法 mg 药物溶于 μL DMSO溶液(母液浓度 mg/mL,

体内配方配制方法μL DMSO母液,加入 μL PEG300,混匀澄清后加入μL Tween 80,混匀澄清后加入 μL Saline/PBS/ddH2O,混匀澄清。

1. 首先保证母液是澄清的;
           2. 一定要按照顺序依次将溶剂加入,进行下一步操作之前必须保证上一步操作得到的是澄清的溶液,可采用涡旋、超声或水浴加热等物理方法助溶。

剂量转换

对于不同动物的给药剂量换算,您也可以参考 更多